MANUALS

Download the Micro-Mini Launcher Manual

Download the Bleacher-Reacher Pro Launcher Manual

Download the Deuce Manual

Download the Bleacher Reacher MEGA Manual

VIDEOS

How to Fill a Co2 Tank (high bandwidth)

How to Fill a Co2 Tank (low bandwidth)

How to Roll A T-Shirt

Regulator Tech

To reset the Pressure Stop Point on your launcher, use a 1/8th Allen Wrench.  Turn counter-clockwise to adjust pressure down or Clockwise to adjust pressure up.  Reg can be turned off & no air will enter the charge chamber if needed for maintenance. 

Folding Tips for T-Shirts

1. Fold T-Shirt in half                         2. Fold Sleeves in

  3. Fold in half again              4. Starting from the neck, begin a tight roll. 
                                                    As the roll is done, a slight pull on the opposite
                                                     end will insure the tightness of the roll.

5. Test to make sure the shirt fits into the barrel of the launcher easily –
if it does, the roll should be secured with rubber bands, balloons, tape,
etc. to make sure it maintains a tight roll.

Note:  The tighter the shirt fits into the barrel, the farther it will travel.  Likewise, distance is affected by how loose the roll is in the barrel.  A tightly rolled shirt will go farther in distance than a loosely rolled shirt.

TO FILL YOUR OWN CO2 TANKS:

You will need:  A 20lb or larger bulk tank from your local Gas/Welding supplier, the Fill Station included with your launcher, and your CO2 tanks. (A digital 10lb scale is also highly recommended)

               (PIC 1)                                             (PIC 2)                                     (PIC 3)

To fill the tank: Filling a C02 tank is simple but it can be dangerous if you are not careful. Screw the tank into your fill adapter (PIC 1) and tighten down the pin depressor until you feel resistance. (PIC 2)  With the bleed valve open (shown in PIC 2), any CO2 in your tank will escape, chilling the tank. If your tank is empty, you should close the bleed valve on the fill station (PIC 3), open the valve on your bulk tank (PIC 3) and fill to about 2oz on your scale. Turn bulk tank OFF and open bleed valve to empty your CO2 tank and chill. (PIC 3)  Now you are ready to fill your tank.  With the bleed valve closed on your fill station and the bulk tank turned on, you will fill a twenty-ounce tank to about seventeen ounces. This way if the gas expands, your tank pressure will not rise above safe levels.  Close your bulk tank valve, and unscrew the fill adapter until you feel the resistance of the valve pin decrease sufficiently. Open the bleed valve to bleed the excess C02 that's in the line and unscrew the CO2 tank.  Your 20oz tank is now filled.  Repeat as needed for multiple tank fills.